Sometime ago, I wrote a tutorial on how to use the Craft Robo. The CR software has changed a little since then,but I do occasionally still get asked for the tutorial, so if you are looking for it. Here it is.
Skating on Thin Ice
Life as observed from the side of the rink
Hi Bev,
I recently purchased a Craft Robo and having a difficult time learning to use it! Have not gotten support from the company I purchased from nor Graphtec USA except a link to UKScrappers, where I finally found you!
I just read your tutorial and really like the simplistic way you explained things but I sure need further instructions.
I just have not figured out the Registration marks or how to make them work!
Do you have any other tutuorial available or do you know how I can get any?
Would appreciate any help you could give me.
Gob bless and thanks for the one you did make available!
Grandma Betty
thank you so much your guide to using the Craft ROBO has really helped me and I will now use this lovely machine that has been sitting in my cupboard un-used for a few months.
THANK YOU!!!!!
I really like this blog good job.
Pingback: About Plotters - Page 2 - PaperModelers.com
I just purchased the Craft Robo 330-L and I am lost!
I would like to make word stencils but can’t seem to figure out how to make the letters like A,O, P etc. keep the inner part. I have read for hours on line and can’t find anything to help me make “bridges”
I use Robo Master5.10.
Could you send me in the right direction?
I have come to read your CR tutorial.
Thank you for sharing,
Petrina
hi can you help? I want to learn how to design scalopps oval round what ever help pease
thank you Jacqui xx
I’ve had my Craft Robo 2200 for six months now, and this tutorial was the most helpful thing I’ve found anywhere. Much more helpful than anything that came with machine or even on Graphtec’s website! Thank you so much for posting this simple and practical tutorial!
Thanks very much for your help re the tutorials I havent as yet got a craft robo .
But am serioulsy thinking about it.
You are a star for doing this.
Do you sytill blog?
Thanks and take care
Have a Happy Christmas
Mary Kendrick
Splitcoasters collector-45
hi you are very helpfull but i have already followed your guide but when i get to the end and click print it makes a small noise the nothing :/ any ideas?
I don’t even own a CR anymore, so I really can’t offer any support on these tutorials. They did work when I wrote them, btu I believe the machine has changed since then
I have just got a Graphtec craft ROBOLite (cc300-200) which i am finding
hard work .I have justed watched your page and found it very easy to understand wish i could more info for mine Thanks if any one reads this that can help please get
in touch.Anne